Anyone buy those cheap-o eBay ABS sensors?
#1
Anyone buy those cheap-o eBay ABS sensors?
They are only $30 with free shipping. Dealer wants $160.
http://www.ebay.com/itm/NISSAN-INFIN...b6543c&vxp=mtr
Other than the mounting tab looking a little different, as long as it works, shouldn't matter right?
Anyone have any experience with these?
http://www.ebay.com/itm/NISSAN-INFIN...b6543c&vxp=mtr
Other than the mounting tab looking a little different, as long as it works, shouldn't matter right?
Anyone have any experience with these?
#2
They might work, but I dunno.
Wait a minute...why do you need ABS sensors? Your 96 doesn't have ABS iirc...only 99.
edit - never mind, I'm thinking traction control. ABS wasn't standard on the 4th gen, but it was optional. Regardless, I personally would go OEM on the ABS sensor. Don't want a crap ebay one screwing up on you, do you?
Wait a minute...why do you need ABS sensors? Your 96 doesn't have ABS iirc...only 99.
edit - never mind, I'm thinking traction control. ABS wasn't standard on the 4th gen, but it was optional. Regardless, I personally would go OEM on the ABS sensor. Don't want a crap ebay one screwing up on you, do you?
Last edited by Amerikaner83; 09-17-2012 at 10:04 AM.
#9
Darn...
I went to check here as I need it for inspection by end of Nov. I saw your post, but my hopes were dashed when the cheapest for my 2001 gle LR sensor is 113.99 minimum.
Do you know the resistance of yours? Maybe they are the same but with different mounts.
If I have to put it in with friction fit or epoxy, that would be good.
Alternative would be to put a resistor of .85 - 1.5 ohm (or is it kohms) reset the light and sneak to the garage at under 6 MPH .
I went to check here as I need it for inspection by end of Nov. I saw your post, but my hopes were dashed when the cheapest for my 2001 gle LR sensor is 113.99 minimum.
Do you know the resistance of yours? Maybe they are the same but with different mounts.
If I have to put it in with friction fit or epoxy, that would be good.
Alternative would be to put a resistor of .85 - 1.5 ohm (or is it kohms) reset the light and sneak to the garage at under 6 MPH .
#11
The junkyard is a good source even the 2000-03 fit their a little short too utililize the plastic clip near the ABS pump but you can connect in to the chassis plug and tie wrap them to the structure to secure.....either they work or they don't...they're just magnets!
#12
yup, I'd go to a junkyard first, cheaper than ebay and it'll be OEM 9 times out of ten. Finding a 4th gen in the boneyard shouldn't be too hard, I see way more of those than I do any other gen.
Thread
Thread Starter
Forum
Replies
Last Post